49 lines
No EOL
2.1 KiB
Bash
Executable file
49 lines
No EOL
2.1 KiB
Bash
Executable file
#!/bin/bash
|
|
|
|
function set_CMDLINE () {
|
|
clear
|
|
# Get the config paths
|
|
source "$SCRIPTDIR/lib/paths.sh"
|
|
|
|
local CMDLINE=$(cat "$SCRIPTDIR/config/kernel_args")
|
|
|
|
printf "Configuration is now complete, however no changes have been done to your system.
|
|
The files needed have just been written to $SCRIPTDIR/config/etc
|
|
|
|
At this point if you know what you are doing, you can use these files to enable VFIO on your system
|
|
and achieve GPU Passthrough with your VMs by moving them to the correct location and then updating your
|
|
initramfs and bootloader.
|
|
|
|
For VFIO to work properly you need to make sure these kernel parameters are in your bootloader entry:
|
|
#-----------------------------------------------#
|
|
$CMDLINE
|
|
#-----------------------------------------------#
|
|
|
|
Make sure that the files inside \"$SCRIPTDIR/config/etc\" are copied to your /etc
|
|
AND PLEASE MAKE A BACKUP FIRST!
|
|
|
|
Then run \"sudo update-initramfs -u\", that way you can boot an older kernel and edit out
|
|
the vfio kernel arguments if your system does not boot after this so you can restore your files from your backup.
|
|
|
|
Finally reboot your system and run \"$SCRIPTDIR/vfio-verify\" to check if your GPU is properly set up.
|
|
NOTE: Some AMD GPUs will require the vendor-reset kernel module from https://github.com/gnif/vendor-reset to be installed!
|
|
|
|
The files inside \"$SCRIPTDIR/$QUICKEMU\" are currently unused files, however they provide
|
|
the required information that the QuickEMU project can hook into and use to add support for VFIO enabled VMs.
|
|
|
|
######################################################################
|
|
#### In the future, when I have enough confirmation that this script works for other people.
|
|
#### This page will get replaced with a prompt asking if you want to apply the changes and make backups
|
|
#### of your current system config.
|
|
######################################################################
|
|
|
|
"
|
|
}
|
|
|
|
|
|
function main () {
|
|
SCRIPTDIR=$(dirname `which $0` | perl -pe "s/\/\.\.\/lib//" | perl -pe "s/\/lib$//")
|
|
set_CMDLINE
|
|
}
|
|
|
|
main |